1. In the process of daily use of plastic granulators, the rotation of the disc must be checked from time to time. The rotation speed of the discs must be controlled within a reasonable range according to the specific provisions of the plastic granulator, so as not to cause the disc to rotate too fast And affect the granularity of the product.
2. As the plastic granulator is a wet granulation model, the upper part of the disc is usually equipped with a spray device to wet the material and increase the viscosity of the material. Therefore, in order to ensure that the material has good adhesion, it should be checked frequently. Spray device to ensure that the water path in the spray device is unblocked.
3. In the process of using the plastic granulator, it is particularly necessary to pay attention to the transmission parts of the plastic granulator, that is, the transmission gear. The rotation of the transmission gear is completed with the assistance of lubricant, so it runs on the gear. In the process, it is necessary to regularly check its lubrication, and properly add lubricating oil and grease to the gears to ensure the good lubrication of the gears, so that the operation of the plastic pellet machine is more stable and reliable.
4. The overall structure of the plastic particle crusher is supported by a frame. When the machine is running, pay attention to check whether the anchor bolts connecting the frame to the ground are securely loosened. If you find that the bolts are loose, you must Tighten it in time, otherwise the plastic pellet machine will generate strong vibration and noise during operation, and even cause accidents.
5. It should be checked whether the parts of the plastic granulator are lost during transportation, and whether the bolts are loose.
6. The plastic granule grinder rotates the main shaft pulley to check whether there is a collision phenomenon during the rotation.
7. After connecting the plastic granulator motor, check whether the rotation direction is correct.
8. It is strictly forbidden to mix iron and sundries in the crushed material of plastic granulator.
9. Plastic granulator should stop immediately if abnormal noise is found.
10. Regularly check the lubrication phenomenon in the bearings of the plastic particle crusher, and inject the lubricant.